|
DSCF1416.jpg
The top of the glovebox is an excellent spot for the high beam ballast as there is a post protruding that you can screw the bracket down to.
Date: 03/04/2008
Views: 218
|
DSCF1419.jpg
Once you have secured everything in place, plug in the ballast power wires and bulb connections, then splice the ballast power wires to the outlet supply wires and splice the solenoid wires to the stock high beam wires.
Date: 03/04/2008
Views: 210
|
DSCF1435.jpg
Once you have everything connected up top, drop the bulb down so it hangs out the bottom in the wheel well.
Date: 03/04/2008
Views: 209
|
|
DSCF1436.jpg
The following may vary between manufactures, but this type bulb has a locking bracket to fit the bulb into an h4 slot.
Date: 03/04/2008
Views: 221
|
DSCF1438.jpg
Rotate the bracket to the open position and slide it forward and off of the bulb.
Date: 03/04/2008
Views: 207
|
photo5.jpg
*Photo provided by Mitch Bergsma Remove the rubber boot on the back. Then remove the stock bulb from the socket by pushing in and up on the retention clip on the top left side near the bulb.
Date: 11/12/2008
Views: 142
|
|
photo2.jpg
*Photo provided by Mitch Bergsma Next, slide the middle portion of the rubber boot onto the back of the Hid bulb mount and push the outside back onto the back of the headlight assembly. Then, place the bulb into the mount and rotate to lock in place.
Date: 11/12/2008
Views: 149
|
photo1.jpg
*Photo provided by Mitch Bergsma
Date: 11/12/2008
Views: 141
|
DSCF1439.jpg
Date: 03/04/2008
Views: 206
|
