|
CIMG2441
Stainless steel brackets were made to fit the point of attachment thru the driver foot rest to the frame. A sharp blads knife was used to cut a section of the plastic the same size as the bracket. A small drill bit was used to cut thru the plastic surro
Date: 01/05/2006
Views: 1321
|
CIMG2442
The passenger foot rest showing the stainless steel bracket in position.
Date: 01/05/2006
Views: 1038
|
CIMG2527
The crash bars were bent to the conture of the scooter and welded to the brackets. four brackets were made for each side...two on the driver footrest and two on the passenger footrest.
Date: 01/12/2006
Views: 1082
|
|
CIMG2528
Showing the rear attachment of the crash bar.
Date: 01/12/2006
Views: 1106
|
CIMG2526
Showing the front attachment.
Date: 01/12/2006
Views: 1082
|
CIMG2530
Showing the rear attachment
Date: 01/12/2006
Views: 1064
|
|
CIMG2532
Finished product. Clean and simple.
Date: 01/12/2006
Views: 1385
|
CIMG2533
Finsihed product. Clean and simple.
Date: 01/12/2006
Views: 1199
|
CIMG2531
Finished product. Clean and simple.
Date: 01/12/2006
Views: 1180
|
